Skip to Content
Pro Attachment Series™
Power Head Shaft to Lower Shaft Assembly
1
Parts Required: PAS or SRM-SB Power Head Shaft and Coupling
2
Set Power Head/Shaft Assembly on a level surface.
3
Pull locater pin (A) out, and turn counterclockwise one-quarter turn to lock-out position.
4
Remove storage hook and cap from attachment drive shaft.
5
Note: Your coupler may appear different than coupler shown. Earlier model power heads may have shorter couplings.
6
Carefully fit attachment drive shaft assembly into coupler (B). Rotate the shaft (C) to make sure the inner lower drive shaft engages the square upper drive shaft socket.
7
Note: Lower bearing housing and head assembly must be in line with the engine.
Some models have an assembly line decal to assist in assembly.
8
Rotate locater pin (A) onequarter turn clockwise to engage lower shaft hole. Make sure locater pin is fully engaged by rotating the lower drive shaft. Locater pin should snap flush in coupler. Full engagement will prevent further shaft rotation.
9