Lubrication

Loosen clamping knob (A)
Pull locater pin (B) and rotate ¼ turn counterclockwise to
lockout position.
Remove attachment.
Remove coupler from upper drive shaft assembly by
loosening clamping screw (C) and removing set screw (D).
Remove upper flex cable (E), wipe clean, and apply a thin coating of 15 ml (0.5 oz.) of grease.
Install cable. Make sure that the flex cable fully engages into the clutch square drive socket.
Slide coupler on upper drive shaft until fully seated, and align set screw hole in coupling with hole in upper drive shaft.
Install and tighten set screw (D), and tighten clamping screw (C).

Need more help?