Pro Attachment Series™

Clean all loose debris from gear case.

Remove plug (A) and check level of grease.

Add grease if necessary. DO NOT over-fill.

Loosen screw (B) and remove locating screw (C). Pull gear
case and shield from drive shaft housing.

Pull flexible cable (D) from the drive shaft housing, wipe clean and re-coat with 15 ml (0.5 oz.) of grease.

Slide the flexible cable (D) back in the drive housing. DO NOT get dirt on the flex cable.

Install the gear housing and shield assembly.

Loosen handle clamping screw (B) and slide throttle handle forward.

Loosen clamping screw (C) and slide shaft out of power
head.

Pull flex cable (D) out of shaft
housing, wipe clean and recoat with 15 ml (0.5 oz.)
grease.

Slide flex cable (D) back into
shaft housing. DO NOT get dirt
on flex cable.

Reassemble in reverse order.