Skip to Content
Hedge Trimmers
Starting Cold Engine
1
Stop Switch
Step 1.
Stop Switch Move stop switch (A) away from the STOP position.
2
Move the choke
Step 2.
Move choke (B) to Cold Start (closed) position
3
Purge Bulb
Step 3.
Pump purge bulb (C) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional four or five times.
4
Recoil Starter
Step 4.
Lay the unit on a flat, clear area. Grip the support handle securely with one hand, and pull the recoil starter handle (D) until engine fires (or 5 pulls maximum).
5
Choke
Step 5.
After engine fires (or 5 pulls), move choke (B) to the RUN (open) position. Restart engine if necessary and allow unit to warm up at idle for several minutes.
Note: If engine does not start with choke in “RUN” position after 5 pulls, repeat instructions 2 - 5
6
Throttle Trigger
Step 6.
After engine warm-up, grip the throttle handle and support handle. Depress the throttle trigger lockout (E), and gradually depress throttle trigger (F) to increase engine RPM to operating speed.