Generators & Inverters

1. Turn the 3-in-1 switch knob to “OFF” (1)
   

2. Remove the fuel tank cap, remove the filter. Extract the fuel from the fuel tank into an approved gasoline container. Then, install the fuel tank cap.

3. Start the engine (See Page 18) and leave it running until it stops. The engine stops in approx. 20 minutes by running out of fuel.

4. Remove the screws, and then remove the cover

5. Drain the fuel from the carburetor by loosening the drain screw on the carburetor float chamber.

6. Turn the 3 in 1 switch to “OFF”

7. Tighten the drain screw.

8. Install the cover and tighten the screws

9. Turn the fuel tank cap air vent knob to “OFF” after the engine has completely cooled down.

Perform the following steps to protect the cylinder, piston ring, etc. from corrosion.

1. Remove the spark plug, pour about one tablespoon of SAE 10W-30 into the spark plug hole and reinstall the spark plug. Recoil start the engine by turning over several times (with 3-in-1 switch knob off) to coat the cylinder walls with oil.

2. Pull the recoil starter until you feel compression. Then stop pulling. (This
   prevents the cylinder and valves from rusting).

3. Clean exterior of the generator. Store the generator in a dry, well-ventilated
   place, with the cover placed over it.