Engine overheats and / or stalls under cutting load | Cut-off Saws & Concrete Saws

Skip to Content

Cut-off Saws & Concrete SawsEngine overheats and / or stalls under cutting load

Engine overheats and / or stalls under cutting load

Try this solution

try the following

Use proper amount of oil in fuel mixture
Clean air intake grid on starter side, flywheel, cylinder fins and surrounding area
See “Carburetor Adjustment” or seek authorized dealer for adjustment

Possible causes:

Not enough oil
Air passages around cylinder clogged
Carburetor main adjustment is set too “Lean

Need more help?

Ask a different questionCut-off Saws & Concrete Saws

Select a different product

On this page