Skip to Content
Chainsaws
Storage
Units equipped with a Momentary STOP Switch automatically return to RUN position. Engine can start unintentionally. Always remove spark plug lead from spark plug before assembling or performing maintenance procedures. Serious personal injury can result.
1
• Inspect and adjust every part of the chainsaw.
• Completely clean every part and repair if necessary.
• Apply thin coating of oil on metal parts to prevent rust.
2
• Remove chain and guide bar.
3
• Drain fuel tank completely. Press purge bulb six to seven times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.
4
• Allow engine to cool. Remove the spark plug lead from the spark plug. Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.
5
• Store in a dry area, free from dust.
6
Do not store in an enclosure where fuel fumes may accumulate or reach an open flame or spark.
7
Do not lend or rent your chainsaw without the Operator’s Manual.
• For future reference, you should keep this Operator’s Manual.
• If this Operator’s Manual becomes illegible or is lost, please contact your dealer, or go to www.echo-usa.com.