Skip to Content
Chainsaws
Starting Cold Engine
Make sure the bar and chain are free from any obstruction when starting the chainsaw
1
Move chain brake lever fully FORWARD to LOCK chain brake before starting.
2
Fill the fuel tank with fuel mixture. Do not over fill.
3
Fill the chain oil tank with lubricant. Do not over fill.
4
Move STOP switch (A) UP to “RUN” position.
5
Press the decompression device (B).
6
Pull choke control knob (C) all the way out (closed [ ] choke position).
7
◆ After choke control knob is pulled and then knob is returned to original position, throttle remains slightly open (fast idle latch condition). ◆ The chain will attempt to move when engine is started with fast idle throttle latch engaged. ◆ Do not start engine before chain brake is locked.
8
Securely hold the chainsaw and pull starter handle until first starting sound.
9
Push choke control knob (C) all the way in (open choke position).
10
Pull starter handle to start the engine.
11
Note: Do not pull starter rope out to the maximum possible position.
12
Note: Do not allow recoil handle to snap back against the casing.
13
Note: If engine does not start after 5 pulls, repeat instructions.
14