Skip to Content
Chainsaws
Starting Cold Engine
Make sure the bar and chain are free from any obstruction when starting the chainsaw
1
Move chain brake lever fully forward to lock chain brake before starting.
2
Fill the fuel tank with fuel mixture. Do not over fill.
3
Fill the chain oil tank with lubricant. Do not over fill.
4
Move ignition switch (A) to “RUN” position.
5
Push purge pump (B) 3 to 4 times or until fuel is visible in purge pump.
6
Pull choke control knob all the way out (Closed Choke) position
7
After choke control knob is pulled and then knob is returned to original position, throttle remains slightly open (fast idle latch condition). • The chain will attempt to move when engine is started with fast idle throttle latch engaged. • Do not start engine before chain brake is locked.
8
Securely hold the chain saw and pull starter handle several times until first starting sound.
9
Push choke control knob all the way in.
10
Pull starter handle to start the engine.
11
Note: Do not pull starter rope out to the maximum possible position. Do not allow recoil handle to snap back against the casing.
12
Note: If engine does not start after 5 pulls, repeat instructions
13