Starting Cold Engine | Chainsaws

Skip to Content

ChainsawsStarting Cold Engine

Starting Cold Engine

Make sure the bar and chain are free from any obstruction when starting the chainsaw

1

Move chain brake lever fully FORWARD to LOCK chain brake before starting.

2

Fill the fuel tank with fuel mixture. Do not over fill.

3

Fill the chain oil tank with lubricant. Do not over fill.

4

Pull choke control knob (A) all the way OUT (CLOSED [ ] choke position).

5

Push purge pump (B) 3 to 4 times or until fuel is visible in purge pump.

6

Securely hold the chainsaw and pull starter handle several times until first starting sound.

7

Push choke control knob (A) all the way IN (OPEN [ ]choke position).

8

Pull starter handle to start the engine.

9

When engine starts, immediately squeeze and release throttle trigger (C) to release fast idle throttle latch otherwise severe brake damage may occur.

10

Note: Do not pull starter rope out to the maximum possible position. Do not allow recoil handle to snap back against the case. If engine does not start after 5 pulls, repeat instructions. Do not increase engine speed while chain brake is locked. Severe brake damage will result.

Need more help?

Ask a different questionChainsaws

Select a different product