Skip to Content
Chainsaws
Starting Cold Engine
Make sure the bar and chain are free from any obstruction when starting the chainsaw
1
Move chain brake lever fully FORWARD to LOCK chain brake before starting.
2
Fill fuel tank with fuel mixture. Do not over fill.
3
Fill chain oil tank with lubricant. Do not over fill.
4
Push purge pump (A) 3 to 5 times or until fuel is visible in purge pump.
5
Pull choke control knob (B) all the way OUT (CLOSED [ ] choke position).
6
After choke control knob is pulled and then knob is returned to original position, throttle remains slightly open (fast idle latch condition). Chain will attempt to move when engine is started with fast idle throttle latch engaged. Do not start engine before chain brake is locked
7
Securely hold the chain saw and pull starter handle several times until first starting sound.
8
Push choke control knob (B) all the way IN (OPEN choke position).
9
Pull starter handle to start the engine.
10
Note: Do not pull starter rope out to maximum possible position.
11
Note: Do not allow recoil handle to snap back against the casing.
12
Note: If engine does not start after 5 pulls, repeat instructions.
13