Starting Cold Engine | Chainsaws

Skip to Content

ChainsawsStarting Cold Engine

Starting Cold Engine

Make sure the bar and chain are free from any obstruction when starting the chainsaw

1

Move chain brake lever fully FORWARD to LOCK chain brake before starting.

2

Fill the fuel tank with fuel mixture. Do not over fill.

3

Fill the chain oil tank with lubricant. Do not over fill.

4

Move stop switch (A) to “RUN” position.

5

Push purge pump (B) three to four times or until fuel is visible in purge pump.

6

Pull choke control knob all the way OUT (CLOSED [ ] choke position).

7

Securely hold the chainsaw and pull starter handle several times until first starting sound.

8

Push choke control knob all the way IN (OPEN [ ]choke position).

9

Pull starter handle to start the engine.

10

Note: Do not pull starter rope out to the maximum possible position. Do not allow recoil handle to snap back against the case. If engine does not start after five pulls, repeat instructions. Do not increase engine speed while chain brake is locked. Severe brake damage will result.

Need more help?

Ask a different questionChainsaws

Select a different product