Starting Cold Engine | Chainsaws

Skip to Content

ChainsawsStarting Cold Engine

Starting Cold Engine

Make sure the bar and chain are free from any obstruction when starting the chainsaw

1

Move chain brake lever fully forward to lock chain brake before starting.

2

Fill the fuel tank with fuel mixture. Do not over fill.

3

Fill the chain oil tank with lubricant. Do not over fill.

4

Pull choke control knob (A) all the way out (closed choke position).

5

Push purge bulb (B) 3 to 4 times or until fuel is visible in purge bulb.

6

Securely hold the chainsaw as shown and pull starter handle several times until first starting sound.

7

Push choke control knob (A) all the way in (open choke position).

8

Pull starter handle to start the engine.

9

When engine starts, immediately squeeze and release throttle trigger (C) to release fast idle throttle latch otherwise severe brake damage may occur.

10

Do not pull starter rope out to the maximum possible position. Do not allow recoil handle to snap back against the case. If engine does not start after 5 pulls, repeat instructions. Do not increase engine speed while chain brake is locked. Severe brake damage will result.

Need more help?

Ask a different questionChainsaws

Select a different product