Skip to Content
Chainsaws
Starting Cold Engine
Make sure the bar and chain are free from any obstruction when starting the chainsaw
1
Move chain brake lever (A) fully FORWARD to LOCK chain brake before starting.
2
Fill the fuel tank with fuel mixture. Do not over fill.
3
Fill the chain oil tank with lubricant. Do not over fill.
4
Move STOP switch (B) to RUN position.
5
Press purge bulb (C) 8 times or until fuel is visible in the purge bulb.
6
Turn choke control knob (D) counterclockwise to (CLOSED choke position).
7
◆ After choke control knob is turned and the knob returned to original position, throttle will remain slightly open (latch condition). ◆ The chain will attempt to move when engine is started with fast idle throttle latch engaged. ◆ Do not start engine before chain brake is locked.
8
Securely hold the chainsaw and pull starter handle (E) several times until first starting sound.
9
Note: Do not pull starter rope out to the maximum possible position. Do not allow starter handle to snap back against the casing. If engine does not start after 5 pulls, repeat instructions.
10
Turn choke control knob (D) clockwise to (OPEN choke position).
11