Skip to Content
Chainsaws
Starting Cold Engine
Make sure the bar and chain are free from any obstruction when starting the chainsaw
1
Move chain brake lever fully FORWARD to LOCK chain brake before starting.
2
Fill the fuel tank with fuel mixture. Do not over fill.
3
Fill the chain oil tank with lubricant. Do not over fill.
4
Push purge pump (A) 3 to 5 times or until fuel is visible in purge pump.
5
Pull choke control knob (B) all the way OUT (CLOSED [ ] choke position).
6
After choke control knob is pulled and then knob is returned to original position, throttle remains slightly open (fast idle latch condition). ◆ The chain will attempt to move when engine is started with fast idle throttle latch engaged. ◆ Do not start engine before chain brake is locked.
7
Securely hold the chain saw and pull starter handle several times until first starting sound.
8
Push choke control knob (B) all the way IN (OPEN choke position).
9
Pull starter handle to start the engine.
10
Note: Do not pull starter rope out to the maximum possible position.
11
Note: Do not allow recoil handle to snap back against the casing
12
Note: If engine does not start after 5 pulls, repeat instructions.
13