Skip to Content
Storage
Blowers

Blowers

Storage

When storing the product for long periods of time, ensure that the following preparations for storage are carried out.

During operation the muffler or catalytic muffler and
surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

1

1. Store unit in a dry, dust free place, out of the reach of children.

2

2. Place the stop switch or lever in the “OFF” position.

3

3. Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4

4. Perform all periodic lubrication and services that are required.

5

5. Tighten all the screws and nuts.

6

6. Drain fuel tank completely. Press purge bulb 6 -7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7

7. Allow engine to cool. Remove the spark plug lead from the spark plug. Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

8

8. Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

9

9. Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

10

10. Install the spark plug. Connect the spark plug lead to the spark plug.

11

11. Remove blower pipe assembly from unit.

Need more help?

Ask a different question
Select a different product
©2025 ECHO INCORPORATED, ALL RIGHTS RESERVEDSitemap
SHOPStore LocatorApparelParts CatalogBuy Service Parts
Sitemap