Skip to Content
Blowers
Starting Warm Engine
The starting procedure is the same as Cold Start except DO NOT close the choke.
1
Move stop switch (A) away from the STOP position.
2
Move throttle position lever (B) midway between idle and full throttle positions.
3
Pump purge bulb (D) until fuel is visible and flows freely in the clear fuel tank return line
4
Place the unit on a flat, clear area. Firmly grasp throttle handle with left hand and rapidly pull recoil starter handle/rope (E) until engine fires.
5
Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for starting. Do not allow the rope to snap back in. Always hold the unit firmly.
6