Skip to Content
Blowers
Starting Cold Engine
1
Move stop switch (A) away from the STOP position.
2
Note: Engine will not run if safety switch is not activated.
3
Move throttle position lever (B) midway between idle and full throttle positions.
4
Move choke (C) to COLD START ( ) (closed) position.
5
Pump purge bulb (D) until fuel is visible and flows freely in the clear fuel tank return line.
6
Recoil starter: Use short pulls - only 1/2 to 2/3 of rope for starting. Do not allow the rope to snap back in. Always hold the unit firmly
7
Place the unit on a flat, clear area. Firmly grasp throttle handle (E) with left hand and rapidly pull recoil starter handle (F) until engine fires, or maximum 5 pulls.
8
Move choke lever to RUN position ( ), and if necessary, restart engine.
9
Note: If engine does not start with choke in RUN position after 5 pulls, repeat instructions 3 - 6.
10
After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.
Note: Allow engine to warm up 3 minutes before use.