Skip to Content
Blowers
Starting Cold Engine
1
Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back in. Always hold the unit firmly.
2
PB-755S H Move throttle position lever (A) to IDLE DETENT position.
3
PB-755S T Move throttle position lever (A) forward to IDLE position. Slide stop switch (B) forward to RUN position.
4
PB-755S H and T Move choke (C) up to COLD START ( ) position.
5
Pump purge bulb (D) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.
6
Pull recoil starter handle (E) until engine fires (5 or 6 pulls maximum).
7
Move choke (C) down to RUN ( ) position, and if necessary, restart engine.
8
Note: If engine does not start after 5 pulls, move choke to COLD START ( ) position, and repeat steps 4 & 5.
9